Set the Mount Body on top of the barrel so that it fits over the Barrel Clamp and the Dovetail Nut.Set the rifle upright on the table and slide the Dovetail Nut into the dovetail notch in the barrel where the rear sight had been.DO NOT snug this screw down yet! (figure 2) Insert the 8-32 Cap head screw through the flange of the Barrel Clamp and start it into the threaded side of the flange. Slide the new Barrel Clamp over the rifle barrel and the front of the carbine stock to the position where the original barrel band had been.Use a small hammer to tap the punch and push the rear sight from the dovetail notch in the barrel. Position a small brass or plastic punch against the base of the rear sight. Use a towel or pad to protect the stock from scratching. Place the rifle on its side on a flat and sturdy table or bench surface.Loosen the cross-screw in the original barrel band, and take off the barrel band toward the front.STEP #2 REMOVE THE REAR SIGHT & BARREL CLAMP Work the bolt handle several times and check the chamber AGAIN.PULL the operating rod completely to the REAR and CHECK the chamber.REMOVE the magazine completely and set it aside.NEVER let the muzzle point at anything you are not willing destroy.
BE POSITIVE THAT YOUR RIFLE IS NOT LOADED